微波吸收法研究Mn,Cu掺杂对ZnS:Mn,Cu光生载流子复合过程的影响

采用微波吸收法，测量了ZnS:Mn,Cu粉末材料受到超短脉冲激光激发后，其光生电子和浅束缚态电子的衰减过程.发现Mn,Cu的浓度对导带电子的寿命有明显的影响，提高掺杂浓度会使光生电子的寿命大大缩短，还研究了掺杂浓度对光致发光强度的影响. 关键词： 发光材料 硫化锌 光电子 微波吸收技术     

反向驱动的异质结有机薄膜电致发光

成功制备了结构为ITO／PDDOPV／PPQ／Al的异质结聚合物发光二极管。该器件在正反向偏压下均可发光。在正向偏压下的光发射主要来自PDDOPV，但在反向偏压下的光发射则包括来自PPQ的蓝光发射和PDDOPV的黄光发射。蓝光强度与黄光强度的比值随着反向偏压的增加而增加，当反向直流电压分别为22V、24V、26V、28V时，其电致发光光谱中PPQ与PDDOPV的峰高比IPPQ／IPDDOPV分别为1．092、1．329、1．605、2．046。换句话说，该器件的发光颜色是压控可调的，这对实现彩色显示是极为有利的。分析了在反向偏压下的发光机理以及IPPQ／IPDDOPV受电压控制的原因。     

YLiF4: Er3+, Tm3+, Yb3+中Tm3+浓度对上转换发光的影响

利用水热法合成了YLiF4: Er3 , Tm3 , Yb3 , 其中Er3 和Yb3 的浓度保持固定不变, 分别为1 mol%和1.5 mol%, Tm3 浓度变化范围是2 mol%～8 mol%. 在这种共掺杂体系中, 同时观察到了Er3 , Tm3 和Yb3 的吸收, 且Tm3 的吸收随着其浓度的增强而增强. 在980 nm光的激发下, 当Tm3 浓度很小时, 这种材料的上转换发光为白光. 其中蓝光主要来源于Tm3 的激发态1G4到基态3H6的跃迁, 绿光来源于Er3 的4S3/2和2H11/2到基态4I15/2的跃迁, 红光既来源于Tm3 的1G4→3F4的跃迁, 也来源于Er3 的4F9/2→4I15/2的跃迁. 并且这种上转换发光强度随着Tm3 浓度的增强而降低, 但对应不同能级跃迁的发光强度降低的幅度不同, 这是因为Er3 和Tm3 之间的相互作用.     

Growth Behavior of CdS Nanoparticles Embedded in Polymer and Sol-Gel Silica Matrices: Relationship with Surface-State Related Luminescence

Chemical techniques were employed to synthesize CdS nanoparticles embedded in polymer (PEG 300) and sol-gel silica matrices. Systematic growth of particles (radius 3–9 nm) was obtained by adjusting post-deposition annealing temperature and time to examine the dependence of surface-state–related luminescence on particle size. Photoluminescence (PL) peak energy showed a linear dependence with a gentle slope in the weak confinement region and a steep slope in the strong confinement region, the divergence being observed near the excitonic Bohr radius for CdS. The empirical relation proposed for the weak confinement region could be used for estimating chemically prepared CdS nanoparticle size with a high degree of reliability from PL peak energy.     

Upconversion luminescence of Tm^3＋/Yb^3＋ codoped oxyfluoride glasses

Novel oxyfluoride glasses are developed with the composition of 30SiO2-15Al2O3-28PbF2-22CdF2-0.1TmF3 - xYbF3 - （4.9 - x） AlF3（x=0, 0.5, 1.0, 1.5, 2.0） in tool fraction, Furthermore, the upconversion luminescence characteristics under a 970nm excitation are investigated. Intense blue, red and near infrared luminescences peaked at 453nm, 476nm, 647nm and 789nm, which correspond to the transitions of Tm^3＋： ^1D2 →^3F4, ^1G4 →^3H6, ^1G4 →^3F4, and ^3H4 →^3H6, respectively, are observed. Due to the sensitization of Yb^3＋ ions, all the upconversion luminescence intensities are enhanced considerably with Yb^3＋ concentration increasing. The upconversion mechanisms are discussed based on the energy matching rule and quadratic dependence on excitation power. The results indicate that the dominant mechanism is the excited state absorption for those upconversion emissions.     

Bipyridinophane‐containing conjugated polymers modulated with an intramolecular aromatic C?H/π interaction

Bipyridinophane–fluorene conjugated copolymers have been synthesized via Suzuki and Heck coupling reactions from 5,8‐dibromo‐2,11‐dithia[3]paracyclo[3](4,4′)‐2,2′‐bipyridinophane and suitable fluorene precursors. Poly[2,7‐(9,9‐dihexylfluorene)‐co‐alt‐5,8‐(2,11‐dithia[3]paracyclo[3](4,4′)‐2,2′‐bipyridinophane)] ( P7 ) exhibits large absorption and emission redshifts of 20 and 34 nm, respectively, with respect to its planar reference polymer Poly[2,7‐(9,9‐dihexylfluorene)‐co‐alt‐1,4‐(2,5‐dimethylbenzene)] ( P11 ), which bears the same polymer backbone as P7 . These spectral shifts originate from intramolecular aromatic C? H/π interactions, which are evidenced by ultraviolet–visible and ¹H NMR spectra as well as X‐ray single‐crystal structural analysis. However, the effect of the intramolecular aromatic C? H/π interactions on the spectral shift in poly[9,9‐dihexylfluorene‐2,7‐yleneethynylene‐co‐alt‐5,8‐(2,11‐dithia[3]paracyclo[3](4,4′)‐2,2′‐bipyridinophane)] ( P10 ) is much weaker. Most interestingly, the quenching behaviors of these two conjugated polymers are largely dependent on the polymer backbone. For example, the fluorescence of P7 is efficiently quenched by Cu²⁺, Co²⁺, Ni²⁺, Zn²⁺, Mn²⁺, and Ag⁺ ions. In contrast, only Cu²⁺, Co²⁺, and Ni²⁺ ions can partially quench the fluorescence of P10 , but much less efficiently than the fluorescence of P7 . The static Stern–Volmer quenching constants of Cu²⁺, Co²⁺, and Ni²⁺ ions toward P7 are of the order of 10⁶ M^?1, being 1300, 2500, and 37,300 times larger than those of P10 , respectively. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 4154–4164, 2006     

稀土氟化物Y0.97Er0.03F3纳米材料的制备及上转换发光

通过燃烧法和控温热反应法制备了稀土氟化物纳米材料，利用XRD和TEM对样品进行了分析和表征。测量了发射波长为980nm激光二极管激发下所得纳米材料的上转换发光性质。     

Collisional Relaxation of Luminescence Anisotropy in Rarefied Gases in the Condensed Phase

The orientational relaxation of optically induced anisotropy in rarefied gases and at a damped rotation has been investigated. It has been found that the anisotropy relaxation in rarefied gases is described by a reduced kinetic equation depending only on free rotation integrals. The behavior of the integral anisotropy of luminescence for free symmetric and asymmetric top molecules has been elucidated. The law of luminescence depolarization has been obtained for asymmetric top molecules in the Gordon J-diffusion model. It represents the sum of two Stern–Volmer-type dependences, whose relative contribution is determined by the orientation of the dipole moments of transitions with absorption and emission of light in the molecular coordinate system and by the principal moments of inertia of the molecular top. It has been established that in the limit of a strongly damped rotation, kinetic equations of the general form reduce to equations of rotational diffusion. A number of modified diffusion equations correctly describing the contribution of inertial effects to the orientational relaxation of anisotropy have been obtained.     

Optical properties of a high-efficiency glass ceramic X-ray storage phosphor

The turbidity, photoluminescence, and photo-stimulated luminescence (PSL) of fluorozirconate glass containing barium chloride nano- and micro-crystals have been measured for samples prepared by isochronal (70 min) annealing over a temperature range of 220–283°C, and correlated with the microstructure as determined by X-ray diffraction measurements. Crystallization of hexagonal phase barium chloride commences at around 220°C, but until 275°C the material retains excellent transparency although it displays negligible PSL. Between 275°C and 277°C, the hexagonal phase converts to the orthorhombic phase, the transparency abruptly decreases, and the PSL rises to a value of around 13% of that found for the commercial storage phosphor BaFBr:Eu. For a slightly higher temperature of 280°C, new phases appear which correspond to the onset of bulk crystallization, and at 283°C the relative PSL rises to 33%, while the transparency falls further. The trade-off between optical transparency and PSL over this narrow temperature window for X-ray imaging plate applications is briefly discussed.     

The response of thermally and optically stimulated luminescence from Al2O3:C to high-energy heavy charged particles

The thermoluminescence (TL) and optically stimulated luminescence (OSL) response of Al₂O₃ dosimeters to high-energy heavy charged particles (HCP) has been studied using the heavy ion medical accelarator at Chiba, Japan. The samples were Al₂O₃ single-crystal chips, of the type usually known as TLD-500, and Luxel^TM dosimeters (Al₂O₃:C powder in plastic) from Landauer Inc. The samples were exposed to ⁴He (150 MeV/u), ¹²C (400 MeV/u), ²⁸Si (490 MeV/u) and ⁵⁶Fe (500 MeV/u) ions, with linear energy transfer values covering the range from 2.26 to 189 keV/μm in water and doses from 1 to 100 mGy (to water). A ⁹⁰Sr/⁹⁰Y beta source, calibrated against a ⁶⁰Co secondary standard, was used for calibration purposes. For OSL, we used both continuous-wave OSL measurements (CW-OSL, using green light stimulation at 525 nm) and pulsed OSL measurements (POSL, using 532 nm stimulation from a Nd:YAG Q-switched laser). The efficiencies (η_HCP,γ) of the different HCPs at producing OSL or TL were observed to depend not only upon the linear energy transfer (LET) of the HCP, but also upon the sample type (single crystal chip or Luxel^TM) and the luminescence method used to define the signal—i.e. TL, CW-OSL initial intensity, CW-OSL total area, or POSL. Observed changes in shape of the decay curve lead to potential methods for extracting LET information of unknown radiation fields. A discussion of the results is given, including the potential use of OSL from Al₂O₃ in the areas of space radiation dosimetry and radiation oncology.